Carbs - Removing Unnecessary Bits Of Wiring Loom

[barneys66 124 1 Cars]

Afternoon all - thought now would be a good time to permanently remove a couple of bits of the loom that are no longer required as I'm running carbs.

 

Question is how best to remove them - I have no plans to revert to stock in the future, so it can be considered a permanent change. I only had a very brief look inside, but assume both of these spurs form part of the main loom, i.e. there's no simple way to unplug them at the bulkhead, so should I just cut them / heatshrink the ends..? Would you cut a little or a lot..?

 

These are the two in question, together with where they enter the cabin. All advice welcome!

 

 

 

 

 

[Miles 331 1 Cars]

One's alarm rubbish so just cut it out and trace back if it's been connected anywhere, the ECU loom being a early type is removed as well, just check the fuel pump wiring not knowing how you have done it

[barneys66 124 1 Cars]

Thanks Miles!