306 Hdi Fuel Pump In Tank

[JayCC 0]

Hi All,

 

Does anyone know what is the +V and -V on the fuel pump conenctor? I think its Pin2 and Pin3 to enable the pump to prime.

 

When taking a multimeter to the feed plug, turn ignition on, it reads 12v on pin 2 and 3 for 3 secs then drops to 3v.

 

I just want to make sure the pump is dud before buying a new one.

 

cheers

 

[mikeyd 13]

hate to say it but the pumps have a reputation for failing - mine was running fine but wouldnt start 8 hours later -tapping it helped but only temporary solution so more likely than wiring

good luck!

[JayCC 0]

cheers mikey

 

just trying to figure out the 12v feed, is it the two central pins? as show in this pic?

 

[pugdamo 111 2 Cars]

I havnt got a wiring diagram to hand but normally you have 2 thick wires and 2 thinner ones, the thicker ones are for the pump the thin ones are for the gauge

[Richie-Van-GTi 71 2 Cars]

Pins 2 and 5 to the fuel pump. Earth is the green yellow one. Found info @ http://community.preloved.co.uk/forums/discussion/17111/help-306-hdi-died.html

[Uberderv 6]

Pin 3 +12v pin 4 earth. Rest is for level sensor.