Brake Servo Vacuum Seal

[Kane 34]

I'm at the last stages of my Mi conversion and have misplaced the rubber seal that is fitted around the white vacuum bung located on the brake servo. I'm sure I have it somewhere amongst all my spare bits in the garage but cannot for the life of me remember what it looks like so wondered if anyone had a picture they could post up to help me out.

 

Cheers

 

Kane

[jackherer 543]

[Kane 34]

Cheers Kieran, task for tomorrow is to try locate where I've put it

[jackherer 543]

Sounds familiar, I think I probably spend about two hours looking for things I know I have for every hour I actually work on a car.

[Kane 34]

Just out of interest what models of 205, or any other Peugeot/Citreon share the brake servo as fitted to the 1.9 Gti? On the lookout for a replacement vacuum seal ,as above, and thought I might have more luck at a scrappies if there were other models with the same part.

[Ryan 99]

The servos themselves vary from model to model, but the seal looks to be the same on more or less all of them.

Edited August 21, 2014 by Ryan

[Kane 34]

Good good,thanks Ryan.

[Kane 34]

Does anyone know if these are sold by Peugeot individually? Been on servicebox but can't locate a part number. Thought it might be an idea to try the dealer before hunting the scrappies.

[jackherer 543]

It's 4599.15 but that is the seal and the white plastic 90 degree piece together for £22.52!

[Kane 34]

Faaarkk! That's a bit steep, that'll be a last resort I think

[welshpug 1,657]

It is a one way valve not just a 90 elbow.

[jackherer 543]

If they are standard across a lot of manufacturers something like this - http://www.ebay.co.uk/itm/131110486853 - might be the same but I can't be sure, it definitely looks right.

[Kane 34]

Funny you put up that link Kieran. I went looking up in the other garage today just on the off chance I'd put any spares up there, no spares but I had a rummage around in my old mini clubman I have and turns out their servo has the exact same seal.

 

I don't plan on retaining any of the mechanical items on the mini so just nabbed that fitted it to the 205 and presto we're all ready for the launch, well I hope so.