Pas Pressure And Joining Of High-Pressure Pipe?

[B1ack_Mi16 67]

Does anyone know the pressure output from the PAS pumps on the pugs?

 

I assume it's more or less the same over the 205,309,405 range etc.?

 

I will need to make a joint between two free pipe ends as I had to partly make the pipe myself on the T16, and wonder how much pressure it is, and how to actually make a good joint.

 

I was thinking of just buying pipe-nuts and flaring the ends. And then just joint it up with a coupler, (female-female metal piece type).

 

Any ideas welcome.

[petert 578]

I turn up a sleeve, with a step in the middle, and then silver solder.

[christopher 5 1 Cars]

Which pipe is it? The high pressure one is the one that goes down to the previous radiator then beside the battery and beside the turbo to the rack.

 

I have connected part of this with brass water press connections which work fine.

 

The section from under the battery to the rack contains a non return valve. I bought a standard 405 pipe from e-bay with the valve and very carefully bent it to fit

[allanallen 528 2 Cars]

I often use hydraulic compression fittings on the solid high pressure pipes, never had a problem.