Distributor (Dizzy) Adapter Mi16 Fitting Guide

[Monkey 0]

Hello clever people

 

I have been searching on Google and on here, and have yet to find a definitive guide to fitting this adapter.

 

My other issues I think as mostly now cleared up - but I want to make sure this has been fitted correctly before I set about getting the car started again - so far it's been less than successful so I can going to go back to the beginning.

 

Thanks for any links to anything anybody can suggest!

 

Cheers

 

Ben

[welshpug 1,666]

Youre more likely to find details on doing it properly than using one of those tbh!

[Monkey 0]

Agreed, however this is currently what I have to work with.

 

Should i fail, I'll have little choice but to attempt a proper job, but for now I am holding out hope I can make it go!

[Miles 331 1 Cars]

Never seen one, Just set up as per the normal firing order, They all tend to vary and you have to drill holes in the right place

[Monkey 0]

It lives :-)

 

I have done a little searching but am rusty on here in terms of what to search for...

 

Can anybody (Miles?) point me in a direction of a list of wires on the Mi16 needed to make it go and feed a ph1 309gti dash please?

 

I am going to put together a new loom including proper sized earth and power leads to replace the slightly ruined and weedy OE ones - also I will make a new ignition loom and tidy it all into some copex.

 

Also I need to wire the fans back in as it arrived with them wired live to a switch on the dash instead of the correct original wiring using the sensor in the radiator.

 

Still - I am making progress now! It feels good to have a car which works!