Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
td_w

Fuel Filler Assembly

Recommended Posts

td_w

Hey there

 

I have noticed a strong smell of petrol in the car at most times, it gets worse in traffic when stationary.

 

I think its likely to be a seal somewhere as it doesn't look like any leaks.

 

I have looked and looked but cannot find a decent image of how the pipes/filler assembly looks and connects - the inner wing has a large rubber cover over the filler cap part, with a hose clip on it. I assume the pipe is under this and that is just a cover?

 

Does anyone have any images of the whole assembly?

 

Thanks :)

Share this post


Link to post
Share on other sites
Plumbob

I don't have one to hand but I certainly can take one tomorrow afternoon, the filler neck for mine is in the shed. I'll check back tomorrow and see if anyone else has put a photo up for you, if not i'll take a few.

Share this post


Link to post
Share on other sites
td_w

That's really kind, thanks a lot!

Share this post


Link to post
Share on other sites
PhilNW

As well as the filler neck there is also a couple of vent pipes on top of the tank

 

Also look at the rubber pipes connecting to the pump on top of the tank they can perish and weep

Share this post


Link to post
Share on other sites
ATK

Check under the rear drivers side seats - prise off the two plastic covers and see if the fuel pump and sender unit are ok. I'm about to replace my seals on them as everytime I fill up it stinks of petrol and pisses over the side!

Share this post


Link to post
Share on other sites
td_w

Thanks for the reply guys - what am I looking for around the pump and sender? (apart from petrol!) is there any way to tell if the seals are perished easily?

 

Luckily I don't have a rear seat so its easy to check

Share this post


Link to post
Share on other sites
Plumbob

As promised, not a huge amount to see in the photos but there they are!

 

I'd agree with the comments above and say if it smells of petrol most of the time, even when moving it's probably not the filler cap end, most likely a connection under the seat.

post-23982-0-79750700-1402599184_thumb.jpg

post-23982-0-07653100-1402599186_thumb.jpg

Share this post


Link to post
Share on other sites
td_w

Brilliant, this helps understand it. Thank you!

 

So the large rubber cover with hose clip is lose on mine - i am guessing it doesn't actually matter - what is that top cover thing by the filler cap actually for?

 

Cheers

Share this post


Link to post
Share on other sites
Plumbob

The rubber sleeve that's approx 10cm diameter and 30cm long just seals the hole between the filler cap hole and the hole in the wheel arch and creates a "tunnel" for the filler and breather hoses.

Share this post


Link to post
Share on other sites
iPlod999

Another question fuel relayed.

 

Looking towards the rear of the car would one of the units on the tank be the 'floater' which controls the fuel gauge.

 

My gauge moves about a bit. Half a tank of petrol moves up and down between quarter and half on a regular basis.

 

If it is one of these are they serviceable?

 

Regards.

Share this post


Link to post
Share on other sites
Rock Lobster

Mines like that too mate, bloody rubbish! I just figured it was normal tbh! I idly just go on mileage!

Share this post


Link to post
Share on other sites
Tom Fenton

Another question fuel relayed.

 

Looking towards the rear of the car would one of the units on the tank be the 'floater' which controls the fuel gauge.

 

My gauge moves about a bit. Half a tank of petrol moves up and down between quarter and half on a regular basis.

 

If it is one of these are they serviceable?

 

Regards.

The tank level sender unit is the one nearest the centre of the car, accessed through the large plastic plugs under the rear seat.

If yours is playing up bin it fit another.

Do NOT be tempted to mess about with it to try and make it work. A spark from it inside the fuel tank would not end well!

Usually they work well on 205's so just fit a replacement.

Share this post


Link to post
Share on other sites
iPlod999

Thank you.

 

Do you have to know a part number if they are still avaliable?

 

My local main dealer is useless.

 

Cheers.

Share this post


Link to post
Share on other sites
Tom Fenton

Servicebox has all the answers.

Share this post


Link to post
Share on other sites
td_w

Thanks for the help on my question, will have a look tomorrow :)

Share this post


Link to post
Share on other sites
MikeC

From what i see 1527 96

Share this post


Link to post
Share on other sites
MikeC

Here is a pic if you want to view.

Hopefully it works

post-22639-0-23156500-1402675279_thumb.png

Share this post


Link to post
Share on other sites
iPlod999

Thank you MikeC.

 

Me and Servicebox don't get on either. ;)

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×