Info On Jenvey Setup Please

[jorg 11]

Hi

 

Its now time for me to properly sort out my throttle bodes and i could do with some help if possible please. I am using Jenvey 45's on a Satchell Inlet and will be running 8 injectors.

 

Sandy recommended using the PQ2 quadrant lever instead of the linkage kit and as it saved me £80 i took his advice on board now the problem is what i have fitted at the moment just doesn't look right to me (will add a picture later) and I can't work it out.

 

Does anyone have a picture of the PQ2 quadrant actually fitted? I have looked through all the threads on the forum linked to the PQ2 and there are no pictures of it

 

Also can anyone give me some inspiration regards sorting out a throttle stop please. Totally useless with stuff like this!

 

any help people can provide will be appreciated

 

thanks for looking

 

Geoff

 

 

 

 

[welshpug 1,657]

All you need is a cable stop, piece of angle between the two mounting bolts with a hole for the outer cable.

 

have a look on Dcc's project thread should be a picture there, works very nicely

[unariciflocos 49 1 Cars]

http://www.106rallyeforum.com/forum2008/showthread.php?t=82693

 

There's even a downloadable PDF.

[jorg 11]

All you need is a cable stop, piece of angle between the two mounting bolts with a hole for the outer cable.

 

have a look on Dcc's project thread should be a picture there, works very nicely

 

Cheers Mei, will have a look through his project thread now

 

 

http://www.106rallyeforum.com/forum2008/showthread.php?t=82693

 

There's even a downloadable PDF.

 

Hi Andrei, I have just had a look at that link you posted but the pictures and instructions are for the CLS1 linkage are they not?

 

This is what was sent to me from Jenvey when I ordered my bodies with the PQ2 lever:

 

 

 

Is the lever on the other side wrong? (too short)

[johniban 59 1 Cars]

Did you sort this in the end ?