DC2T 50 Posted April 3, 2014 (edited) Quick question, do these fit the 205 or is it a totally different set up? I was just checking the peugeot pcd and noticed that the 4007 are a 5x114 with a wider offset Edited April 3, 2014 by DC2T Share this post Link to post Share on other sites
welshpug 1,646 Posted April 3, 2014 its a Mitsubishi Outlander with a pug engine and a pug badge. its a 2 bolt type hub not a clamp. Share this post Link to post Share on other sites
DC2T 50 Posted April 3, 2014 Pardon my ignorance, but would i be able to use the the actual hub face and fit it to the 205 hub carrier? My terminoligy is appalling sorry haha Share this post Link to post Share on other sites
welshpug 1,646 Posted April 3, 2014 (edited) why would you want oversized japcrap wheels on a 205? depends on the dimensions of the bearing and also the CV joint spline pattern, specifically on that I have no idea. Edited April 3, 2014 by welshpug Share this post Link to post Share on other sites
DC2T 50 Posted April 3, 2014 Theyd only be 15's lol. As im swapping out parts from my dc2 for the turbo build im doing ive got alot of surplus parts to use really, the engines going in, along with red recaros and dash. My plan was to use the wheels too and paint the lot in honda chapionship white. I noticed the offset was 37 -45 i think so may let me run the wheels without spacers to be flush with the dimma arches. im not dead set on it but thats kinda what i have in my mind. Also i considered machining down the hubs to fit the gti carriers that way id have honda/honda splines and could use the standard shafts (cut down perhaps) I know nowt about suspension though lol so stuff i wana do may just not be possible lol Share this post Link to post Share on other sites