205 Ph1 Vent Console Illumination Light Bulb Change

[Rjuhar 52]

How to - please...

[Rjuhar 52]

Please guys, I don't want to break something as ph1 plastic is brittle enough as it is and parts are impossible to find. Thanks

[Slo 283 1 Cars]

Hmm what on earth is a vent console? I have a full phase 1 setup from my car.

[Rjuhar 52]

It's the thing above the radio, where the ventilation sliders are.

 

And I doubt you could help me with any of the interiour bits I would eventually break since I would need to mirror all/most of your parts.

Edited February 14, 2014 by Rjuhar

[Slo 283 1 Cars]

Oh right heater control bulbs, well i'm not looking to sell my phase 1 stuff (although it is in the for sale section) I just meant i could have a look at it and work out the best way to get to the bulbs.

[DamirGTI 344]

You'll need to remove entire lower part of the dash which surrounds heater controls in order to do so .. there really isn't other way .

 

Once the lower part is removed , there will be two screws on the bottom one on the each side of the illumination strip panel .. but first you'll need to remove actual slide control knobs/buttons (just grab them with fingers and pull out) , then after you undone the screws just lift up and release the illumination strip panels .. the bulbs will be underneath .

 

D

[Rjuhar 52]

See, that's what I was talking about. On a UK forum, answered from my neighbour next door!

 

(Hvala ti puno Damir! Moramo se nač na prolječe, vodit ču ženu i kčer u Opatiju u šetnju pa te nazovem. Pozdrav)