Front Bumper Side Fixings

[2052006 10]

I need the whole kit for both sides - there used to ones on ebay, but no longer, at least not when I just searched.

 

Any ideas where to get them?

 

By the kit I mean: metal slider, rubber insert, centre spacer, washer and screw and long T-bolt and nut.

[Slo 283 1 Cars]

There's a seller on ebay that just sold the last pot last night.

 

There are other sellers that sell the metal slides and tom fenton on here sells the bolt and nut/large washer bit (that goes inside the rubber grommet) in stainless.

 

http://www.ebay.co.uk/itm/BRAND-NEW-GENUINE-PEUGEOT-PEUGEOT-205-GTi-CTi-FRONT-OR-REAR-BUMPER-FIXING-KIT-/111252764368?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item19e72e76d0

 

Message them, they might be listing more soon.

Edited February 4, 2014 by Slo

[2052006 10]

Have been watching ebay for these to come up, but nothing...

 

Anybody got some spare or have other ideas on where to obtain them?

[farmer 328 1 Cars]

The bumper slides have went NLA in the last 4 weeks am afraid.

 

Rubbers are still sold and Tom Fenton does the top hats

 

Bumper kits will come with all bolts and clips you need.

 

If you want part numbers let me or Slo know

Edited February 16, 2014 by farmer

[2052006 10]

I see that there are still the long T bolts & nuts on ebay. Will these work for the front as well as the back, do you know?

 

Do Pug sell the rubber bits?

 

Are the metal slides strictly necessary? I can't think off the top of my head, how it all attaches.

[farmer 328 1 Cars]

Yeah they will work, but they are expensive individually and they be may need to be cut down for the sides as they should be shorter.

 

The bumper fitting kits are £24 a set, not bad value as the bolts are £6 each and without a nut for them.

[2052006 10]

I have managed to source one bumper slide from Spoox. I actually ordered two, but they contacted me saying they only had one left, so that is hopefully in the post.

 

Anyone have any idea where I could find a second?

[farmer 328 1 Cars]

NFP from Peugeot and a seriously low supply on stock at any dealers in the world on these am afraid

[Tom Fenton 1,541]

I am currently designing the press tooling to allow me to remake these side brackets.

[farmer 328 1 Cars]

Have an original if needed.

 

Check your PM's please Tom in regards about some O.E stuff you have of mine.

[2052006 10]

It does seem stock has suddenly run out. I'm kicking myself for not buying them when I saw them on ebay a few months ago, I knew I needed them, as the originals had gone in the bin as a pile of rust. Just wish I had known they were about to run out! Tom, I'd definitely be interested in some reproduction ones (or one at least...)