Rear Beam Bearing Diameters

[Bogsye 22]

Ive got to extract the inner bearings from the beam and need to make a puller.

 

Can anyone advise the outer diameter of the bearing please.

 

Only got a couple suitable plates to cut down, otherwise I'd trial and error it..

 

Thanks in advance!

[jord294 91]

If you have an old trailing arm shaft you can use that

[Bogsye 22]

Thanks Jord - I'll have them surplus later on, but at the moment I need the bearings out first, so still plan A.

 

Anyone else know the outer dia?

 

Thanks

[Tom Fenton 1,540]

I have a piece of steel pipe about 6ft long, I find the easiest way to do the inners is to push them away from you first of all, you'll see the beam tube narrows down to the diameter for the inner bearing then flares out again, you can push the inner bearing into the central part of the tube, then spin it 90 deg and shove it through and out the other end.

[Anthony 1,002]

As above - that's how I do it.

 

I don't have the bearing sizes to hand, but if you base it on being the same size as the larger end of the trailing arm shaft (ie the bit that's pressed into the arm) then that should work for the inner bearing.

[pug_ham 244 3 Cars]

I remove the inner bearings in the same method as Tom & Anthony but have also done it using an old trailing arm shaft to push them into the middle of the tube.

 

Six & two threes tbh but to make a puller the inner bearing outside diameter is approx 49mm.

 

g

[Bogsye 22]

Many thanks guys for your collective input - appreciated.

 

I'll give the pulling a shot first, as it's probably a trial for fitting new bearings, and getting the puller up to scratch (that makes it sound sophisticated)

 

Thanks again,

Brian