Thrust Washers Thicknesses And End Float?

[B1ack_Mi16 67]

Hi

 

Started putting my 405 2.2 T16 engine together the other day.

 

Put in the thrust washers yesterday (Glyco 4141AF STD, XU10J2TE) they are marked...

 

Anyway I couldn't feel much end float, cheked the dial gauge and was only able to move it forth-back 2 to 3 thousands of an inch, so about 0.06mm end float.

 

What shall I aim for, and where do I find a listing stating the thickness of my current thrust washers, and other thickness ones?

 

Edited August 1, 2013 by B1ack_Mi16

[JeffR 51]

Not sure if the iron block is different to the XU9J4 which is 0.07-0.27mm end float.

[B1ack_Mi16 67]

Not sure if the iron block is different to the XU9J4 which is 0.07-0.27mm end float.

 

Ah, so then maybe my end float is ok, if I say 3/1000 inch that's 0.076mm

[DamirGTI 342]

Nominal dimension thrust washers : 1.83 / +0.05 +0

 

Repair dimensions :

 

1 - 1.93 / +0.05 +0

 

2 - 1.98 / +0.05 +0

 

3 - 2.03 / +0.05 +0

 

End float : between 0.07 and 0.27

 

(all values in mm.)

 

D

Edited August 3, 2013 by DamirGTI

[B1ack_Mi16 67]

Ok, thanks.

 

I'm tempted to leave it then, even though it might be on the tight side, I'm sure it is at least 3/1000's now

 

Just need to start sourcing those damn M7 bolts for waterpump and sump, over the years they seem to have disapperared somehow...

[welshpug 1,657]

at least they all seem to be still available, though rather expensive, but commonly used on other engines.