205 1.9 8V With Aircon & Pas - Pipe Routing

[dcc 855]

As my haynes book of lies doesn't seem to want to show me the information I need, I turn to you gentlemens and womans.

 

The throttle body on the standard 1.9 8v lump has several breathers, water in and water out for the throttle body warmer.

 

It is a K plate, 1993 Phase 2, coil on inlet, but no vac advance on the distributor.

 

A labelled diagram would be fantastic! (its been a few years since I have had an 8v which worked/wasnt on aftermarket management.

[welshpug 1,661]

Which ones do you want to know?

 

the coolant ones you can do away with and plum straight to the top of the thermostat takeoff, which tidies it up a little, I think yours might have a charcoal canister which is one pipe off the engine side of the throttle body, might also be something electrical screwed into the bottom, and there's a small bore oil breather onto the top from the oil filler, and that's it.

 

the larger port on the oil filler lid goes to the elbow between t/b and afm, smaller one lower down goes round to the front of the block.

 

 

like this, ish.

 

 

 

 

http://www.miamistu.co.uk/pug/GB/205N/1/11C51A.HTM

Edited June 28, 2013 by welshpug

[welshpug 1,661]

And here's most of the cooling hoses.

 

 

 

 

 

 

 

http://www.miamistu.co.uk/pug/GB/205N/1/13G50A.HTM

[dcc 855]

I guess I will need to go take a better look, but I was sure I counted 4 take offs on the throttle body itself

[dcc 855]

oh actually that second image shows everything I needed! nice one

[welshpug 1,661]

yeah, there's a test point and a vac takeoff for the dizzy which both need blanks.

 

have some cooling pipes too

 

[welshpug 1,661]

heater hoses phase 2.

 

 

 

http://www.miamistu.co.uk/pug/GB/205N/6/64K45A.HTM

[dcc 855]

Cheers Mei, useful as ever

[dcc 855]

As it turned out these are quite different to my 205 set up, but the general layout was there, cheers.