Upgrade My 2.0 Xu10J4 To Xu10J4Rs

[nour_peugeot 5 1 Cars]

i have a Peugeot 306 2.0 and i want to upgrade it without change engine

frist Installation of exhaust manifold from xu10j4rs engine

secound Installation power system chip

Third Installation gear box Be4 fros mi16 Xu10j4r

fourth change full exhaust system with anther one 2.5 inch (apexi)

...................................................................................

now i want ask if i can change my cam gears and intake manfold form xu10j4rs on the same ( wiring and control )

and i will uploading pic for my upgrades

thanks for help

[allanallen 528 2 Cars]

Yes you can swap the cams and inlet manifold although it won't run very well on the original engine management.

 

Change your font it's very difficult to read .

[nour_peugeot 5 1 Cars]

ok thanks for help and i will change font

[nour_peugeot 5 1 Cars]

are you sure i didn't need a remaping my control ?

[camgti 56]

Im in the process of changing the Inlet manifold and the exhaust manifold from the GTi6 J4RS to the J4R motor. Im using a different management so im not sure if you need other wiring.

 

There is a guide on here somewhere to help change it over. I think the Map sensor wiring may be a little short but thats about it. Everything else should fit

 

You can also have your cams reground by PeterT to give you a little extra power

 

Cam

[nour_peugeot 5 1 Cars]

so when i want to remaping my ecu any one can help me to change my ecu file ?!

[ORB 227 1 Cars]

Surely it's easier to swap the whole lump?

[nour_peugeot 5 1 Cars]

how ? !

[welshpug 1,657]

very much like whoever installed the J4 engine.

[ORB 227 1 Cars]

Simple.

 

Step one - remove old engine & loom

 

Step two - replace new engine and loom.

[nour_peugeot 5 1 Cars]

there's no one have Gti 6 in egypt just 7 cars at bad condition so i want to rebuilt my engine as i can to get extra power

[camgti 56]

You will need shorter bolts the hold the manifold on. About 8mm shorter. I bought some yesterday from my local bolt shop. You will also need to lengthen the map sensor wire to rear its new position on the bigger inlet. Otherwise it's pretty much the same. You need to gently bend the oil dipstick a little to fit between the runners on the manifold.

[nour_peugeot 5 1 Cars]

i think it's easy to make it there was any ather problems ? !

[JoeVTS 1]

can't you change the whole top end including head? otherwise have the ports on the J4 head ground to match the RS manifolds.