aronw2004 4 1 Cars Posted April 26, 2013 Found these rust holes behind the drivers headlamp. Not to big but needs sorting out. Can i weld a plate over the top and through the hole behind the light or would it be best done fron underneath? Share this post Link to post Share on other sites
welshpug 1,646 Posted April 26, 2013 personally I would not weld "plates" but cut out the rot and weld in new metal. it'll probably pass an MOT as is by the way, mine has for 5 or 6 years! Share this post Link to post Share on other sites
aronw2004 4 1 Cars Posted April 26, 2013 ok, so cut a section out and make a similar one and weld it as it would have been originaly then? I take it that it will not fail the mot on that then? iv got a photo but i cant find how to attach it Share this post Link to post Share on other sites
farmer 328 1 Cars Posted April 26, 2013 I have a new front frame for sale in the wanted section if that interests you. Share this post Link to post Share on other sites
aronw2004 4 1 Cars Posted April 26, 2013 The front panle seems ok thanks. ill weld it up i think, and respray the whole front frame and up to the top mounts i think. it would be a good time to sort the stone chips on the front lower bumper also. Dose any one know where i can get some original stickers for the engine bay? Share this post Link to post Share on other sites
farmer 328 1 Cars Posted April 26, 2013 http://forum.205gtidrivers.com/index.php?showtopic=147765&page=5&do=findComment&comment=1336933 Share this post Link to post Share on other sites
