shooter mcgavin 37 Posted April 15, 2013 Finally got round to knocking up a puller to remove the inner bearings from my 309 beam Bearings were still in one piece surprisingly. I've gave the tube a good clean out and I'm ready to tap in the new bearings but forgot to measure how far in they sit. Does 180mm sound about right? Share this post Link to post Share on other sites
PhilNW 43 Posted April 15, 2013 From recollection - measure off the swing arm as they have to sit on the 2 shoulders of the arm in the right place, make sure you clean out properly mine was full of grease and grit Share this post Link to post Share on other sites
pug_ham 243 3 Cars Posted April 15, 2013 forgot to measure how far in they sit. Does 180mm sound about right? http://www.205gtidrivers.com/articles.html/_/articles-guides/brakes-suspension-steering/rear-beam-refurbishment-guide-r66 Approx 20cm depth for the inner bearing. g 1 Share this post Link to post Share on other sites
