calvinhorse 870 Posted January 11, 2007 im fitting an amp to my mi16 and was wondering the best way i could run the power wire through the bulkhead and into the boot? i routed it under the car last time but im not a big fan of doing it that way. any help much appriciated! Share this post Link to post Share on other sites
PugMi16 0 Posted January 11, 2007 First under the hood find the hole that has rubber stuck in it and that no other installation goes throu somwhere near the steering wheel, then remove plastics that are under the door (keep the door open ) you can pull the cable under those plastics all the way to the trunk! I think there is no other way to pull the through! Share this post Link to post Share on other sites
Guest badboyracer3500 Posted January 11, 2007 First under the hood find the hole that has rubber stuck in it and that no other installation goes throu somwhere near the steering wheel, then remove plastics that are under the door (keep the door open ) you can pull the cable under those plastics all the way to the trunk! I think there is no other way to pull the through! <{POST_SNAPBACK}> yeah, thats the way i done it. Gavin. Share this post Link to post Share on other sites
