Where To Put Lambda On 421..?

[MiniGibbo 142]

My new exhaust manifold

My thing to put the lambda in

the only place my lambda will reach (where im currently planning to put it)

And the problem (distance it is until its a single pipe)

Advice...?????

[RossD 44]

I put mine on the single pipe section at the top, where it goes up and over the subframe. Haven't experienced any problems at all in doing this.

 

Just be careful when you do this so that you dont interfere with the gear linkages etc if you do go for this position.

[MiniGibbo 142]

Never thaught of that as the lambda is very short but should reach there..!!

 

Does it get in the way when you fit the B pipe..?

[welshpug 1,661]

different engine but same principle -

 

http://forum.205gtid...2

 

no issues at all with the gear linkages, but its a standard gearstick.

 

 

distance isn't an issue, that's a shorter length to the lambda than you'd find on the V6 engine, if the lead is too short make it longer or find one with a longer lead, off a 306 if its one plug, or a very early 306 or late 405 if its 2 plug, 405 has a VERY long lead

Edited May 18, 2012 by welshpug

[MiniGibbo 142]

Cheers guys ill have a good look tomorrow morning then..!

 

I saw in my journal you mentioned the306 lambda but i dont fancy paying "new" money and buying second hand sounds like a can of worms idea so im keen to keep mine as i know it works.

[Tom Fenton 1,542]

Lengthen the wires. Done.