Turbo Wiring

[bassline21 1]

hello all. today i got round to taking my dash out and removing the original 205 engine loom from my turbo conversion. im confused as ive removed the whole loom off the car ecu end to sensor end and i only have one brown multiplug on it. i havent cut any wires or anything like that. in all the searches ive done i have found that i need two brown multi plugs from the right of the centre console?? is it the two which are beside the fuse board?? meaning ill have to pull more wires out!! any help much appreciated.

[welshpug 1,661]

sounds like you have an 87 or earlier car which will only have one 4 pin plug, separate auxillary wiring on the other side of the car.

[bassline21 1]

what else do i nedd to take of then? or would i just attach the 406 loom too this 5 pin plug?

[welshpug 1,661]

having done one recently again, I would pull the wires that go to the 5 pin plug back through the dash to near the fusebox, and join the relevant wires on the left side of the car well away from the exhaust.

 

no need to take anything off (other than the round plug on the 406 loom of course)

[bassline21 1]

cheers. anything i should know or take into account before i start??

[jonnyturbo 3]

make sure to take notes and label everything, dont rush.

[bassline21 1]

the other end of this multi plug goes through the bulkhead passenger side. so guessing ill have to trace them out and back in to the fuseboard or ehere ever they go?? thanks jonnyturbo. i will.