[project] 205 Gti 180 Track Car

[Matt180 31]

It was a joint effort with a freind who manufactures fibreglass shells for drag cars.

 

It may be something we will look into producing if there is a market.

[welshpug 1,657]

thought those hub carriers looked familiar, done two saab clutches recently!

[petert 586]

Love the fuel cell, but do you still need a barrier between driver and the rear of the car?

[davenport 51]

Superb work as always!

[Batfink 201]

I like your hub swap. Whats the reason you've gone this route? Bigger bearings, kingpin angle or the simpler fitment for the strut?

[Matt180 31]

Love the fuel cell, but do you still need a barrier between driver and the rear of the car?

Hopefully it wont be a issue, i could make a lid for it though to keep the scrutineers people happy.

[Matt180 31]

I like your hub swap. Whats the reason you've gone this route? Bigger bearings, kingpin angle or the simpler fitment for the strut?

Main reason was the increased distance from BJ to hub centre- should level wishbones and improve roll centre. Next reason was having camber adjustment at the upright rather than on the top mounts.

 

Bearings are the same. I'm yet to weigh the complete front assembly but it should be a little lighter too

[East_Hud 7 1 Cars]

Cracking build this, can't wait to see the results

[Schumi 2]

Over a year. Any updates before new year?