Phase 2 Central Locking

[dino20vt 3]

As i've never owned a phase two and the Haynes manual only covers a phase 1.5, I have a few questions regarding the factory fitted central locking.

 

Are the actuators the same part number for both sides?

 

Are they both switches and motors ie can you lock and unlock from both locks barrels unlike a phase 1.5 where the drivers side is just a switch that tells the passengers side and boot to lock or unlock and the passenger side just operates the near side lock pin.

 

Are the phase 2 actuators on any other PSA cars.

 

I ask as i'm about to fit a Toad alarm to a phase 1.5 but don't want to add an extra motor to the drivers door.

Edited November 13, 2011 by dino20vt

[allye 530 3 Cars]

Just the drivers door is the master barrel. All other locks just operate that door/lock.

[dino20vt 3]

So it's just like a phase 1.5 setup but has a motor in the drivers door and has remote locking?

[Henry Yorke 269 3 Cars]

the phase 2 has a black drivers motor with 3 pins; the third being a feed from the PLIP system which the later models had for remote central locking

[dino20vt 3]

the phase 2 has a black drivers motor with 3 pins; the third being a feed from the PLIP system which the later models had for remote central locking

 

Can a phase 2 drivers actuator be retrofitted?

Where does the control box under the steering wheel come into the equation, is it just a relay between the IR dome and the doors?

Edited November 13, 2011 by dino20vt

[Tesstuff 222]

Why don't you just come over and look at mine you goose!!!

[dino20vt 3]

I might take you up on that, I'll try not to break too many trim clips! :-)

[Tesstuff 222]

Mark is always taking the door cards off , they have survived all his abuse, you will be fine mate

[dino20vt 3]

 

 

There's some new genuine ones on ebay part number 661503, is this the one I need?

 

Can anyone shed any light on which ones which?