Wiring Positions Of Earths

[mhyphenl 10 1 Cars]

I've just got to the point of re wiring my rebuild and, as it's been so long, forgotten where stuff goes. Firstly I've routed the lighting and ABS looms which should go behind the wash bottle IIRC but the earth points dont go anywhere near either the battery tray or brake pipe splitter thingy. Any ideas where they shoud go, Everything reaches where it should by the bulkhead so cant think where Ive gone wrong.

 

 

The other is making shure I've bought the main ECU loom up in the right place, I'm a little more confident with this one!

 

[welshpug 1,657]

there's one earth with a ring that bolts to the gearbox earth lead where it meets the body, and the rest are further forward and pug in by the l/h headlamp

[mhyphenl 10 1 Cars]

there's one earth with a ring that bolts to the gearbox earth lead where it meets the body, and the rest are further forward and pug in by the l/h headlamp

 

I've got the Plug in ones by the headlamps, its the ones that have rings on the end, I've got the gear box one connected which one side goes to the battery neg, question is where does the other side bolt to on the chassis, IIRC the gear box one bolts to the bettery tray but these two don't reach there or anywhere else as far as I can see. Its almost as if the looms have too much length on them now!

[welshpug 1,657]

not sure on a phase 2, but phase 1.5 they bolt down on the ignition amplifier's plate.

[Ryan 99]

I'll have to check, but isn't there a hole on the inner wing down the side of the washer bottle?

[welshpug 1,657]

there was on my phase 2 309