djinuk 2 Posted May 15, 2011 im looking to buy 4 point harness's for my 205. it has a omp cage however this only has a rear diagonal and id need to weld in a harness's bar.. Is there any other way i can mount harness's , pics would be great. Share this post Link to post Share on other sites
rallyeash 155 Posted May 15, 2011 can use the rear seatbelt points. Share this post Link to post Share on other sites
djinuk 2 Posted May 15, 2011 is the angle not to far down ?? Share this post Link to post Share on other sites
Miles 331 1 Cars Posted May 15, 2011 I'd never use those and hate anyone that does as it's just a cheap way out and when Safety comes into it not worth it in my book, It's a very thin pressed bit of metal which is never good, You can even flex some around the mounting point by hand so that says allot Share this post Link to post Share on other sites
djinuk 2 Posted May 16, 2011 so looks that that then a harness bar is pretty much the only way to go. Share this post Link to post Share on other sites
welshpug 1,646 Posted May 16, 2011 so looks that that then a harness bar is pretty much the only way to go. if its a bar welded to the cage yeah Share this post Link to post Share on other sites
mochyndu 0 Posted May 22, 2011 Definately the way to go,as per safety devices c44 roll cage... Share this post Link to post Share on other sites
matt.f 16 Posted May 27, 2011 May be wrong but-Trouble with omp cages is the belts wont come out straight from the holes in the seat to the harness bars because the cage is narrower,im sure they will be at an angle(as pic above shows you are alowed a bit) ,might work but may not look right. Never heard of a problem with putting them through the floor as you get a spreader plate which can be welded to the car,ive rolled in one like this and so have a few other people i know and the floor hasnt moved. But as said it is better to be on a harness bar like most new design cages Share this post Link to post Share on other sites
brumster 135 1 Cars Posted May 27, 2011 You could weld some 3mm plate onto the floor somewhere and bolt through that with the proper mounting plates - provided you made the 3mm plate a decent cross-sectional area (ie. make it the size of a DVD box or bigger) then I doub't you'd rip that through the floor skin on an impact !! Share this post Link to post Share on other sites
Baz 421 Posted May 27, 2011 (edited) OMP cages don't have harness bars?? And that's not the only trouble with them! Edited May 27, 2011 by Baz Share this post Link to post Share on other sites
matt.f 16 Posted May 28, 2011 He means he will weld them in Baz. There are better cages but they do there job, know 2 people who rolled last year with omp cages and they stood up well Share this post Link to post Share on other sites