2.0V Turbo Engine Head Bolt Torque Setting?

[dave205 19]

Anybody know what the torque setting is for the head bolts on a 406 turbo engine, XU10J2cte?

[hanceformer 0]

Just did a head gasket on mine and I was told it is, 35nm working from centre out. Then 75nm centre out then 180 degree turn working inside out again. Done 500 miles on these settings and all seems fine. Hope this helps.

[dave205 19]

Cheers i'll try them, dont suppose you know were i can get all the torque settings for this engine?

[hanceformer 0]

Look up Pugperformance on the net. Ask Collin. He will know.

[dave205 19]

I'll have a look at that, but who's collin?

[welshpug 1,657]

ring a garage or buy a haynes manual

[dave205 19]

406 haynes manual doesnt cover turbo or v6 engines

[hanceformer 0]

Collin is the owner of Pugperformance and has build many of these engines.

[welshpug 1,657]

406 haynes manual doesnt cover turbo or v6 engines

 

 

its just an 8v XU10 with a turbo bolted on, or get a manual that does cover it...

Edited May 10, 2011 by welshpug

[dave205 19]

Yeah but surely a turbo charged engine is under more strain than a n/a one?

[welshpug 1,657]

not these ones, they're lazy low compression constant torque things, less power than a gti6 engine

 

 

 

 

 

by the way, Autodata says 35 Nm, 70 Nm then 160 deg, any garage worth its salt could have told you that

 

Same as the non turbo engine, seeing as its the same head, block and head bolts.

[dave205 19]

Gti-6 engines dont go wooosh though!!

 

I didnt realise so many parts were the same, i have a haynes manual that covers 1.6,1.8,2.0 engines, so i may aswell just follow that?

Or could i just follow a 205 manual?

[hanceformer 0]

Dave u have twice been told the torque settings now by myself and welsh. Why would u follow a 205 manual when u have an xu10 406/xantia engine? :s

[dave205 19]

Point taken hanceformer, i'll have it torqued up in no time!!!

[hanceformer 0]

I change the valve stem seals too while u go the head off.

[dave205 19]

I change the valve stem seals too while u go the head off.

 

Yeah ive changed them, along with everything else, whilest the head was off.

[hanceformer 0]

Good lad because I didn't change mine and now it smokes on down shift like Dot Effing Cotton

[dave205 19]

Good lad because I didn't change mine and now it smokes on down shift like Dot Effing Cotton

 

Haha, thats alot of smoke!