Peugeot 106 Phase 1 Exhaust Manifold

[tdr_1976 41 1 Cars]

Would a Peugeot 106 8V Phase 1 Exhaust manifold flange fit onto my TU3s head? I just want to know before I make a purchase to get one to Modify for my 205.

 

Cheers!

Edited March 23, 2011 by tdr_1976

[welshpug 1,661]

looks like the same part number.

[tdr_1976 41 1 Cars]

Cheers matey!

 

I'm looking at a four branch manifold to modify it to go over the subframe!

[VND 1]

Cheers matey!

 

I'm looking at a four branch manifold to modify it to go over the subframe!

 

If you get profficient at the fabbing, I think theres a gap in the market for selling them on dude!

[tomcolinjones 26]

I fabricated my own from a seccond hand aftermarket 106 tu 4/2/1 branch. it worked very well, the holes are 100% in the correct place. i had to use 3 gaskets as i purchased one with a buckled flange.

weld it up to the original downpipe, blank off the lambda sensor.

 

make sure you weld it spot on, as a little each way could prevent you selecting gears

 

you are welcome to mine for free. i have cut the xs downpipe off it since, but if you can un-bend the flange, it should work fine.

Cheers

Tom

Edited March 24, 2011 by tomcolinjones

[tdr_1976 41 1 Cars]

Hi bud, only just seen your reply!

 

I've purchased a stainless steel 8V 106 4-2-1 manifold, I decided to go stainless in the end.

 

The problem I have now is finding a 2" tube with the correct angles for welding onto the new manifold, I have a chap ready to sort it out for me, I just need to source the tubing now to get it on the car!