lukesaddy 0 Posted March 2, 2011 Hi, i need to get the front bumper off my restoration GTi, the bolts in the arches are just spinning, any ideas ? thanks heres the reason i need it off; http://s556.photobucket.com/albums/ss10/lukesaddy/205%20Gti%201900/?action=view¤t=30012011761.jpg Share this post Link to post Share on other sites
NNPUT 2 Posted March 2, 2011 Hi Luke, i had the same problem recently and asked the very same question. Basically your best bet is to carefully angle grind or hacksaw the bolt of on the indside of the front wing then buy new bumper bolts and mounting brackets. £23 a side on ebay at the momnent i think. Thanks Mark Share this post Link to post Share on other sites
lukesaddy 0 Posted March 2, 2011 hi, thanks for replying Mark, any chance you have a link to the mounts ? thanks Share this post Link to post Share on other sites
sceptre 0 Posted March 2, 2011 Ah, those bolts are awful, they always do that. Make sure you cover the new ones in plenty of grease before fitting them again. clicky I think the above are the longer ones from the sides. The front ones are usually better. Share this post Link to post Share on other sites
DRTDVL 4 1 Cars Posted March 2, 2011 i just grabbed a long screwdriver and wedged it against that rubber circle thingy that it screws into and it fine after that. Share this post Link to post Share on other sites
lukesaddy 0 Posted March 6, 2011 got it off with some perseverance, thanks for the tips chaps Share this post Link to post Share on other sites
Henry Yorke 269 3 Cars Posted March 6, 2011 It is always worth wire brushing the threads, then covering in Plus Gas / WD40 before trying to get them off. If they are very old, you should be pleased if they break otherwise they can mangle the bumper if they spin. The wedge with a screwdriver is a good approach as it keeps the tension on the bolt "head" to reduce the spinning Share this post Link to post Share on other sites