large 33 Posted January 17, 2011 As title, is there any way of pulling out a seat belt if it has gone fully in. Share this post Link to post Share on other sites
james_pug 26 1 Cars Posted January 17, 2011 They usually pull out fine once there bolted in place. Share this post Link to post Share on other sites
allye 530 3 Cars Posted January 17, 2011 (edited) This happened to me when i was converting my 205 van to 5 seats. If I remember when I bolted them in they seemed to come out. Do they not have to be are the correct angle? Edit - beaten to it!! Edited January 17, 2011 by allye Share this post Link to post Share on other sites
engine killer 6 Posted January 18, 2011 A correct angle is a must. If the belt is fully retracted, you may have to keep pulling and letting go to give the retracter a little room to work properly again. It is a little bit tilted no matter front or rear. Share this post Link to post Share on other sites
Baz 421 Posted January 18, 2011 +1 once in place they'll be fine. Share this post Link to post Share on other sites
large 33 Posted January 18, 2011 No sorry people even when bolted into the car at the correct angle they still do not work. Also they are fully retracted, they will not go in any more. Share this post Link to post Share on other sites
allye 530 3 Cars Posted January 18, 2011 Have you got the correct seat belt bolted into the correct position? Worth a try Share this post Link to post Share on other sites
large 33 Posted January 18, 2011 They will only fit one way. Thanks for giving it a go . Share this post Link to post Share on other sites
humanz 3 Posted January 21, 2011 They will only fit one way.Thanks for giving it a go . +1 to what allye said. They can be mixed up tho (drivers for passenger and vice versa), and if u haven't got them on the correct sides, they still wont pull. Failing that, if you're careful they can be taken apart (don't quite remember how, and the plastic cover was slightly damaged, and I had a spare anyways), which might allow you to unstick them. Not sure how that works for MOTs tho. Share this post Link to post Share on other sites
axnutty 10 Posted January 22, 2011 My mate had this issue with a R5. There was a small tab that needed to be pushed in to reset the unit as it were. Have a look and see if theres anything like that on the 205, could well be. Share this post Link to post Share on other sites