Quick Rear Beam Questions

[blessed6383 0]

are these gaps ok as set rer high this morning and there as close as i can get them?

 

also are there suppose to be screws in the ends of the antiroll bar?

 

just wanted o be safe rather than sorry

 

 

 

 

 

[j_turnell 134 3 Cars]

There is a measurement mentioned in the haynes (0.05mm), need a feeler guage. There should be plastic/nylon torx insert that screws into the end of the arb.

Edited October 17, 2010 by j_turnell

[blessed6383 0]

cheers yer have the plastic bit the other side just wondered if there was ment to be metal screw or something as the end of the arb is threaded

[welshpug 1,645]

no, that's just for drawing the end plate on, which should have a 0.5mm gap between the plates and the trailing arm each side too.

 

there should be an offset washer and a screw in the end of the torsion bar too.

[blessed6383 0]

i know about the washer as need to rethread that torsion bar as oher side is complete with the washer etc

was just wondering if the traiing arms were in enough

[smithy 1]

i know about the washer as need to rethread that torsion bar as oher side is complete with the washer etc

was just wondering if the traiing arms were in enough

 

 

difficult to see in picture,as mentioned already you need to insert a 0.05mm feeler between the seal and trailing arm.