Where Does This Pipe Go ?

[giveitsomebar 0]

quick answer please just changed the starter motor on my car and just finishing off and had a bit of a mind blank to where this pipe goes?

 

its the rubber bit between the throttle body and afm it has a pipe at the top and the bottom the bottom doesnt seem to have a rubber pipe on and the top does? the car is a rally car so alot of the breathers have been blocked

 

[Tom Fenton 1,548]

The pipe going under your hand to the oil filler cap is supposed to go to the stub on the bottom of the air intake pipe. The pipe in your hand goes to the oil filler cap.

 

However if you want it to not blow all the seals and piss oil out of every orifice I would un-block the breathers and put them back how they are supposed to be. There is no performance gain whatsoever by blocking them up.

[giveitsomebar 0]

ah what a doughnut i knew it didnt look right. problem i have with the breathers is i dont have the original pipes to fit it so it will have to stay like that for the moment!

 

just tryed turning it over it started twice an now its just clicking and wont have any of it.. back to square one

[stefan 4]

I would say that just maybe the hose going from the oil filler cap is not blocked and is going somewhere behind or even maybe into some kind of can. I disconnect that hose from the inlet to the oil cap because I don't want any oil in there.

The inlet side just block of. That's just how I do it, and also belive that this may be the case here.

That's if you don't want or need the SAD.

Edited August 16, 2010 by stefan