Cylinder Head Setup?

[Carbs4me 45]

Hello all,

 

Ive just started to rebuid my cyclinder head, i have it all stripped down and ready to be rebuilt.. i was wondering what mofications would suit a carb setup (which i am also rebuilding) the carbs are DHLA 40's, im gunna keep the bottom end standard for now, as i have another block which im going to rebuild with awhole load of forged pistons, kinfe edge crank, and 2.1 bores etc...

 

Obvisous modifications:

 

Kent rally ram

Vernier pully

Port and Polish

 

Currently the modifications are Over sized values (unsure of the size but can get these if requested) with these on i was only getting power from 2000RPM to 5500RPM, im looking for a setup from 3000-7500

 

Just wondering if any1 can give me a good setup for the cyclinder head as ive never rebuilt a cyclinder head before... i want to replace all the componets, with performance one's... the cyclinder head has only done 6k miles since it was last rebuilt..

 

Cheers

[Baz 421]

To get the best from the other planned mods it would be a better idea to raise the compression, otherwise it's all a little in vain.

[Carbs4me 45]

ok thanks, i shall wait and do re-do the spare bottom end i have before i even start on the cyclinder head!.... ill post anew tread up on my working progress when i get round to building it back up.