Flywheel Cover Plate

[wah 0]

Hi all,

 

I noticed last week whilst crawling about under my 205 1.9 that there should be a plate covering a inspection hole to view the flywheel, it has been fitted with a BE3 box and who ever has done the job obviously hasn't bothered to replace it !!, what I'm wondering is if anybody has one of these kicking about in the workshop / gagrage / shed that I could have or even know where I could get hold of one !!!

 

 

 

Si

[jord294 92]

i've got one mate

 

do you want the bolts to fasten it on ?

[wah 0]

Wonderful yes please mate PM me

 

Si

 

 

 

 

i've got one mate

 

do you want the bolts to fasten it on ?

[wah 0]

PM'd you last night mate

[Henry Yorke 269 3 Cars]

There are two types of these so you need to make sure you get the right one. I must have a BE1 one as the nice powdercoated one I have does not seem to fit my BE3 box This probably explains the reason yours is missing!

[welshpug 1,657]

The is a difference between 1.6 and 1.9 due to the block stiffening plate.

[jord294 92]

anyone got any proof there are different types, as i have only ever seen one type

 

according to servicebox, only one part number aswell 2107.86

 

[welshpug 1,657]

are you 100% on that? because I can see 2107 A5

[jord294 92]

are you 100% on that? because I can see 2107 A5

 

well spotted mei

[wah 0]

So which is it then as I need a BE3 box one ??? where abouts is it on service box ??

Edited July 8, 2010 by wah

[Ryan 99]

The difference isn't between BE1 and BE3, it's between 1.6 and 1.9. The 1.9 has a shorter plate, otherwise it would catch on the bottom of the sump spacer.

[Henry Yorke 269 3 Cars]

Ahh ok. So I just have a powdercoated 1.6 one (though it would have fitted my engine originally before I fitted the alloy sump).

 

What is the difference between the part numbers then?

[welshpug 1,657]

1.6 + non stiffener plate equipped XU9's, plus diesel engines and XU10's where applicable;

 

 

2107.86:

 

 

all stiffener plate equipped XU9's, this would be the 1.9 MI16 and most 1.9 205 engines.

 

2107 A5

 

 

which is NFP as it happens.

 

IIRC the low compression engines did not use them.

Edited July 9, 2010 by welshpug

[Henry Yorke 269 3 Cars]

IIRC the low compression engines did not use them.

Nope The used the 1.6 ones

[S@m 156]

So which is it then as I need a BE3 box one ??? where abouts is it on service box ??

 

Although everyone seems to know this already ill just clarify, you will find it in the clutch plate/cover section or as servicebox puts it "CLUTCH WTHT RET MECH PLATE BEARING BUFFER" <--------that section; psa being concise as always!

Sam