jason7579 5 Posted May 17, 2010 The pipe pictured (split one going to oil filler cap I think) is getting in the way and I can't get the HT LEad holder to fit in front or behind it? Any ideas? Have I got something on wrong or is it just the wrong hose on that pipe? Share this post Link to post Share on other sites
Anthony 1,002 Posted May 17, 2010 Errrr.... that shouldn't be there. That should be a bleed point for the thermostat. If that goes to the oil filler cap, that pipe should be connected to the top of the throttle body. Share this post Link to post Share on other sites
jason7579 5 Posted May 17, 2010 (edited) Thanks, think I need a good look at my leads and wires then!!! No wonder the hose doesn't fit. Should that pipe have a screw in it then or should it be open? Thanks for the help. Edited May 17, 2010 by jason7579 Share this post Link to post Share on other sites
Anthony 1,002 Posted May 17, 2010 Should that pipe have a screw in it then or should it be open? Should have a plastic thumbscrew in there, but they're almost always snapped off leaving the bleed point sealed. If there was nothing in there, it would gush coolant out (and into the oil filler cap, which would be FAR from ideal) Share this post Link to post Share on other sites
jason7579 5 Posted May 17, 2010 Thanks, think I'll go sort it now. Share this post Link to post Share on other sites
welshpug 1,647 Posted May 17, 2010 mine has a brass bleed screw there with a copper washer, allen key head. Share this post Link to post Share on other sites
Daviewonder 533 3 Cars Posted May 17, 2010 mine has a brass bleed screw there with a copper washer, allen key head. Both of mine have this too Share this post Link to post Share on other sites
jason7579 5 Posted May 18, 2010 Did some midnight mechanics and found out mine has the brass screw too. No idea why the hose went to it? Thanks for the help Share this post Link to post Share on other sites
