AJA_GTi 0 Posted March 4, 2010 Hello, Just did the well arch ride height test and I can get 3 fingers in on the N/S (waits for the giggles ) and 2 plus 5mm slack on O/S. Does this mean I need to adjust the torsion bar or sommat else? Cheers, Share this post Link to post Share on other sites
marksorrento205 80 Posted March 4, 2010 Dont worry about it. Pug say as long as its within 10mm either side iirc. The car will always be driven with a driver, not always a passenger...... Share this post Link to post Share on other sites
AJA_GTi 0 Posted March 4, 2010 (edited) Dont worry about it. Pug say as long as its within 10mm either side iirc. The car will always be driven with a driver, not always a passenger...... Spot on mate that makes sense. Good job i'm no bantam weight Laters Edited March 4, 2010 by AJA_GTi Share this post Link to post Share on other sites
jord294 89 Posted March 4, 2010 does your beam look like its been refurbed in the past ?????????? Share this post Link to post Share on other sites
Anthony 1,002 Posted March 4, 2010 Measuring against the plastic arch isn't particularly accurate to be honest, as it could easily be a few millimetres out side to side. Better bet is to measure against the jacking points and some flat level ground, checking all four corners (make sure the jacking points are still straight first though!) Share this post Link to post Share on other sites
AJA_GTi 0 Posted March 4, 2010 does your beam look like its been refurbed in the past ?????????? Not sure mate - how can I tell? Look for clean shiny bits?? Share this post Link to post Share on other sites
AJA_GTi 0 Posted March 4, 2010 Measuring against the plastic arch isn't particularly accurate to be honest, as it could easily be a few millimetres out side to side. Better bet is to measure against the jacking points and some flat level ground, checking all four corners (make sure the jacking points are still straight first though!) Mate - it handles impecably but someone at work said it looked a bit p*ssed on the gravel car park thats all. I must admit i'd imagine the arches are out rather than anyling else as it's seriously on rails. I'll do a more scientific test as slipping 2 fingers in always ends up bad sorry! Share this post Link to post Share on other sites