Gotta Drill Out A Wheel Bolt

[pugpete1108 62 1 Cars]

I'd go a little further to the base of the taper

 

I doubt you'll have any trouble removing the remains, they usually unscrew by hand, remove the disc and you'll have enough to get a pair of grips on too.

 

ah yes i forgot about the disk, even better

[hcmini1989 16]

ah yes i forgot about the disk, even better

pete if you get really stuck ill post you a socket there for rounded of studs they are like a left hand thred wich cut into the bolt/nut etc when trying to loosen they

range from 8mm to about 19mm so i could post you some off the smaller ones to try

[pugpete1108 62 1 Cars]

pete if you get really stuck ill post you a socket there for rounded of studs they are like a left hand thred wich cut into the bolt/nut etc when trying to loosen they

range from 8mm to about 19mm so i could post you some off the smaller ones to try

 

 

cheers liam, if only you had said two days ago

 

i think its gone a bit far for that now though as there aint much bolt left. it'll be out by tomorrow or the angle grinder will be.

[EdCherry 34 1 Cars]

Get the angle grinder out now, hockey mask and lots of lights. Scare it enough and it might just losen itself...

[pugpete1108 62 1 Cars]

in my area i would give it five mins before i got nicked, tempting though

[pugpete1108 62 1 Cars]

finally got the little bastid out today, got a good 13mm bit down there and had to go a bit deeper than i tought but didnt mangle the wheel at all which is a result.

 

and i managed to get the last bit out with a pair of grips quite easily.

 

this would be the remains: