DRTDVL 4 1 Cars Posted February 16, 2010 Hello... before you all just on the just search... i spent 2 hours trolling the forum last night... and yes i'm probably very useless at searching... For some reason i was under the impression that only the 309 GTI control arms where suitable to use in the 205, last night i was hunting through the parts catalog found the following models have the same part number listed for the control arm. CARBURETTOR XU92C http://www.stuartmcguire.co.uk/pug/GB/309F/3/35B15A.HTM INJECTION XU5JA XU9J1 XU9JAZ XU9M http://www.stuartmcguire.co.uk/pug/GB/309F/3/35B25A.HTM INJECTION XU9J4 http://www.stuartmcguire.co.uk/pug/GB/309F/3/35B35A.HTM Is there any difference between, stronger, weaker, ball joint size, etc... If there isn't it would make it much easier trying to find a set. Share this post Link to post Share on other sites
j_turnell 134 3 Cars Posted February 16, 2010 AFAIK they were only fitted to the gti and the Dturbo. Share this post Link to post Share on other sites
welshpug 1,645 Posted February 16, 2010 turbo diesel models use them too, wont make them any easier to find I doubt, they are under the same part number after all. Share this post Link to post Share on other sites
Miles 331 1 Cars Posted February 16, 2010 I know Motaquid don;t sell them anymore so I doubt Peugeot does, Your only choice is the low quality Far Eastern ones Share this post Link to post Share on other sites
DRTDVL 4 1 Cars Posted February 17, 2010 what about this place: http://www.rockauto.com/catalog/ Share this post Link to post Share on other sites
j_turnell 134 3 Cars Posted February 17, 2010 I've always found quinton hazell good quality parts, which are listed on the link above. Share this post Link to post Share on other sites