Cooling Circuit

[Daviewonder 533 3 Cars]

Hello

 

Been having a look at how to plumb in the cooling system on my xu10j2cte conversion, Ive looked at a lot of threads and drawings from this forum but they all seem to mention "T" pieces but from what ive seen on my engine it looks quite straight forward with no "T" pieces.

Can anyone check my drawing and see if theres any problems with it?

 

 

Ta

[Tom Fenton 1,542]

Where do the heater pipes run from-to?

[Daviewonder 533 3 Cars]

one comes from the pipe at the back of the block on the n/s and the other goes onto the side of the thermostat housing.

Edited January 31, 2010 by Daviewonder

[Miles 331 1 Cars]

You;ve forgotton the Top of the Stat housing to the Header tank too, You'll be hard pushed to get 2 pipes down the back of the engine which is why the T is used

[Daviewonder 533 3 Cars]

I didnt notice any other pipes on the thermostat housing, only the front to the rad top hose and the side to the matrix. you say the other one is on top?

[Miles 331 1 Cars]

You'll find them blanked off, Or the turbo engine out of the 406 I had did, Just unscrew one and re-fit the pipe, Keep to the 205 system as much as possible

[Daviewonder 533 3 Cars]

Ok I'll have a look, cheers miles