How To Fit Omex Rev Limiter

[evo rich 0]

right just bort my self an omex rev limiter of ebay but got no manuel with it any way iv had a go at fitting it and i cant realy get it to werk proply so dont no if iv got a problem with the unit or its just me. i conected the red wire to the live on the coil wich i thort it would be the red wire then the blue 1 to the negitive the wight 1 then the black to the bodey but it only lights up if i rub the black earth on the body but cant get it to stay on and the earth has a good contact. i have trid the wires on the coil the other way round as well. so if any 1 can help thanks rich

[sideways danny 0]

http://www.omextechnology.co.uk/Revlimiter...erdownloads.htm

[evo rich 0]

http://www.omextechnology.co.uk/Revlimiter...erdownloads.htm

thanks for that all i need to no now then wich is the + and - on the coil its an mi16 on r1 carbs with dizzy set up thanks rich

Edited December 21, 2009 by evo rich

[MrG 3]

have a go at searching this site, there's been a few subjects regards the polarity of coils etc for the omex limiters. Is the coil a stand alone item or on the inlet manifold?

[evo rich 0]

have a go at searching this site, there's been a few subjects regards the polarity of coils etc for the omex limiters. Is the coil a stand alone item or on the inlet manifold?

it stands alone mi16 on r1 carbs with no rev limiter

[evo rich 0]

it stands alone mi16 on r1 carbs with no rev limiter

iv still not sorted this i no wot all the wires are for on the omex but how is it fitted to the coil. my coil is an 8v coil set up i think I'm running carbs any help would be great thanks rich

[MrG 3]

I had 4 wires from the Omex, red, black, blue and yellow. The yellow is redundant unless you use the launch control feature, so I've just tapped that up and tucked it away. The black is earth (and it needs a good earth). The blue/red fits plus/neg as required.

It doesn't light up when in operation though or when the cars running, the lights only light up when the thing is being set up, and that's explained in the download handbook/guide etc.

I've connected it to the coil by connecting them originally by wrapping the ends around the terminals but now by way of proper connectors, still does the job.