Ecu Pins Which Is Which?

[A2TheA 0]

doea anyone know where i can find a diagram of the mi16 2 row ecu with the pins labelled up so i know which ones to test?

 

i am checking the afm and the collenat temp sensor. anyone got a picture or a diagram?

 

Thanks

Aaron

[welshpug 1,657]

there are numbers on the plug, I can't remember if they are wire side or not so you may need to remove the black cover section.

[A2TheA 0]

there are numbers on the plug, I can't remember if they are wire side or not so you may need to remove the black cover section.

 

 

thanks but i have just come across GLP's schematic diagram for the 2 row ecu. it should be pinned somewhere so it can be found easily.

 

thanks anyway

 

sorry for posting without looking properly (it took some digging though )

 

Thanks

 

Aaron

[DrSarty 90 1 Cars]

Here ya go. This also shows what readings to expect under different conditions.

 

(P.S. ET09 DVD will be posted in one week by a colleague coming back to the UK - sorry for the delay - cheque inside)

2_row_ECU.pdf

Edited December 9, 2009 by DrSarty

[Veero 1]

Rich I don't suppose you have one of those Autodata sheets for the 3 row?

[DrSarty 90 1 Cars]

Rich I don't suppose you have one of those Autodata sheets for the 3 row?

 

3_row_for_Veero.pdf

[Veero 1]

Mint

[A2TheA 0]

thanks rich. i just found it before you posted it very very helpful but im still struggling to fix the f**king problem with it.

 

i am in talks with miles to take it on. fingers crossed aye.

 

Aaron

[24seven 104]

Sorry for the bump but cheers for the 3 row pin list from me too.

[24seven 104]

ok sorry to bump again, but there are a good few discrepancies between that pin list and my ECU/loom. /The knock sensor shares a pin with the ECT, and some of the pins in my plug have nothing listed at all (I mean pins with actual connectors too, not blanks). The ECU side of the loom hasn't been touched at all, so it's not been mismatched.

[DrSarty 90 1 Cars]

ok sorry to bump again, but there are a good few discrepancies between that pin list and my ECU/loom. /The knock sensor shares a pin with the ECT, and some of the pins in my plug have nothing listed at all (I mean pins with actual connectors too, not blanks). The ECU side of the loom hasn't been touched at all, so it's not been mismatched.

 

Some sensors will share pins; they will most likely be sensor grounds.