Bucket Seat Mounting?

[rallysteve 22]

My 205 project shell already has seat rails welded in supposedly ready for bucket seats. There are 4 bolt holes for each seat. I have measured these holes and found the rear two holes are slightly lower and are closer together than the front ones. As i dont currently have any seats i cant compare the fit.

 

Does anyone have a spare seat around who could take measurements of the mounting points could they? should they be in a level square?

 

Cheers Steve

[boombang 2]

Sorry to say but all mounts and seats vary.

 

One seat with certain mounts may be a perfect fit, another won't be anywhere near.

 

No major hassle to weld on some 3mm plate and redrill though.

Edited October 29, 2009 by boombang

[Cameron 16]

That isn't a problem, it's meant to be like that as bucket seats are narrower at the rear than the front.