Crank Sensor For Kms

[Guest ron_swinkels]

Hello,

 

I am building a Mi16 with TB's and KMS ecu. I have a problem with the wiring from the crank sensor. I use the original Peugeot sensor and Peugeot cable to the KMS. It is a 3 pin connenctor and the cable is 2 colours and a shield. The colours are red and green. I don't know which number of the connector what is.

I want to know which number the signal is and which number the ground. I think dat pin 3 the shield is. Because pin 1-2 = 380 ohm. I read that it should be between 300-500 ohm.

 

pin 1 = ??

pin 2 = ??

pin 3 = shield

 

I have already read the link below, but I can't find it.

 

http://www.forum.205gtidrivers.com/lofiver...php/t87803.html

 

If somebody want's to know what I'm builing, check Swinkels Racing

 

Can somebody help me.

 

Thank you already.

 

Greetings Ron Swinkels

Edited September 1, 2009 by ron_swinkels

[pugpete1108 62 1 Cars]

why dont you just connect them up and see what works ?its either one way or the other.

 

thats what i did on my ms setup

[Sandy 191]

Pin1 signal

Pin2 signal earth

Pin3 screen

 

Connect pin3 to pin2 at the ECU end.