8v Xu9 Cylinder Head Spray Bar

[Chile 0]

Hello,

I'm currently rebuilding the head of my 8v XU9 engine. I removed the spray bar from the cylinder head and discovered that 2 o-ring are in bad state and that one was missing. Does anyone knows what are the dimensions of this o-rings and/or were i can get them from?

Also I would like some tips to clean the spray bar the spray bar.

regards

[johny105_y2k 1]

i cleaned mine with an airline blower, then checked it by submersing it in oil at one end and blowing down it and watching for the bubbles.

 

as for o-rings i would assume they are just a standard size.

 

johny

[welshpug 1,657]

1166 21 qty req - x5 RING-SEAL DIAM INT 5,10 96p + VAT.

[Chile 0]

Excellent, thank you very much!

[Pob 1]

1166 21 qty req - x5 RING-SEAL DIAM INT 5,10 96p + VAT.

 

What pack size do they come in? 5? It's so annoying when you have to have the whole pack on stuff they don't stock...

 

Dan

[welshpug 1,657]

have no idea, they are listed as singles but you need 5.

[DooBeDooBeDo 1]

I just bought some starter motor bolts from Pug - they were listed individually - but I had to buy 4...

[welshpug 1,657]

you didn't HAVE to buy 4, but the dealer was trying his luck as a they dont really want parts that come from the factory/warehouse in multiples to be sat on the shelf.

[Chile 0]

I´ve got the o-rings but know i can´t fit the spray bar back in. Any recommendations to fit it back?