Gti-6 Idle Control Valve Plug Connector

[Doof 11]

Anyone know what sort of connector this is? I want to buy a new one from vehicle wiring products but i don't know what type of connection it is. Think it's some sort of supaseal connector but want to make sure it's right.

 

Cheers,

 

Lewis

[Sandy 191]

It looks like superseal, but I think it's different. Is it broken?

[Cameron 16]

I'm not sure its a superseal one, I've been trying to find it on Servicebox so I can add one to my Emerald loom but can't find it. Might have to just get one from the scrap yard and then try and source the pins.

[Doof 11]

Well, its not a superseal jobbie, just ordered one and it's too big. Think i'll have to just connect my wires up to the existing ones. Slightly rough but i'm stumped otherwise.

[DrSarty 90 1 Cars]

Well, its not a superseal jobbie, just ordered one and it's too big. Think i'll have to just connect my wires up to the existing ones. Slightly rough but i'm stumped otherwise.

 

I thought it was SuperSeal! Anyway. The way I did it when I WAS planning to run the GTI6 inlet complete with ICV, was simply to go to a scrappies and look under a Peugeot bonnet. I seem to remember I got my connector with about 8inches of fly-off wires (pigtails) from a 306 diesel. Should be fairly common Doof.

 

Then all you need is a decent stripper/set of side cutters, soldering iron and heatshrink. Jobbus dunnus.

[Miles 331 1 Cars]

It's easy to use the 2 wire Mi16 IACV, just blank the stepper motor off and use a pipe to the Mi16 one