Megajolt Using Map

[PVFCpug 6]

spotted a unit available which is the V3 Megajolt but is a MAP set-up only, question I have is can this be used on a twin 45 set up and where would you MAP pick up from. Would this mean messing about with the manifold. Is there perhaps a way to modify board from MAP to TPS?

[pug_ham 244 3 Cars]

Doesn't the inlet manifold have a port for the servo you could tap into for the MAP sensor?

 

Although thats probably not ideal because it'll only sense the demand for one cylinder.

 

Graham.

[Tom Fenton 1,542]

For what they cost I'd hold out for a TPS version to be honest.

[mattbenselin 0]

An MJ meant for taking MAP readings will work with carbs but to get the signal close to being stable you would need to make a take off on each runner and some kind of chamber to stablilise the air. Hold out for a TPS one as Tom said.